Tectonic™ Folding Truck Bed Cover
Our Tectonic Dual Motion folding cover will not be compatible with most fifth wheel/gooseneck setups due to the width and height of the panel stack. The following information will help you to determine compatibility with your setup.
Panel Width and stacked panel height.
Making tight turns or traveling on uneven terrain may cause your trailer to come into contact with the Tectonic panel stack. Click the following link to view what the specific panel width and height will be for your truck. What is the Height/Width/Weight of the Tectonic™ panels and rails?
Landmark™ Retractable Truck Bed Cover
Hitch Clearance
Peragon retractable tonneau covers are popular among fifth wheel travel trailer owners because of its unique open-into-the-bed design that preserves rear visibility while driving and allows you to keep the cover in place. The cover works with many different fifth wheel hitches and the following will help you determine if your fifth wheel setup will be compatible.
The top of the fifth wheel hitch much be at least one inch below the top of your truck bed rail and the forward most part of your hitch must be at least 20 inches or more from the inside wall at the cab.
King Pin Box and Rail Clearance
Landmark rails extend into the bed roughly 3 inches on each side. Depending on your setup this can affect your turn radius. King pin box may come into contact with our rails if making a hard turn.
The Landmark rails protrude about 1 inch above your truck bed rail. You will want to check to make sure you have adequate room between top of Landmark rail and bottom of fifth wheel cap. It is recommended to have a minimum of 5 inches of clearance.