Classic, Platinum, and Limited HD Edition Covers.
To replace the rail cross piece seal on a Classic, Platinum, and Limited HD Edition cover watch the following video.
Limited HDx Edition Cover.
To replace the rail cross piece seal on a Limited HDx Edition use the following steps.
1. Remove the old seal and clean the surface with rubbing alcohol and allow the surface to dry fully.
2. Peel back a couple of inches of the red tape.
3. Align the end of the seal with the end of the rail. Adhesive part of the seal will make contact with the inside edge of the rail while the non-adhesive part will fold over the rail lip. See image below.
4. Continue to pull several inches of the red tape away at a time and press the adhesive part of the seal into the rail firmly to get good adhesion.
5. When you come to the other end of the rail, cut the seal flush with the rail lip.
6. Go back down the full length of the rail pressing the adhesion part of the seal into the rail to ensure good adhesion.